G6 V6-3.9L VIN 1 (2006)
2. Hold the switch in the active close position.
3. The window and the sunshade will travel to the full open position and then stall or hard stop approximately 1 second, then return to the full closed
position. This is also known as the soft stop position.
4. Hold the switch for approximately 2 seconds. The profile data is saved to the EEPROM.
IMPORTANT:
-
The Teach Procedure is not complete if one of the following occurs before the cycle has finished:
-
The rotary switch is moved from the closed position.
-
The sunshade switch is not held continuously in the activate close position.
-
Ignition and/or battery power have been removed.
-
The window and/or the sunshade have not reached the full soft stop close position after opening.
-
If the Teach Procedure is not carried out completely, only part of the profile data will be stored, and the Teach Procedure must be started again.
-
If the ignition is inactive, neither the window lamella nor the sunshade can be moved by the rotary switch.
-
If the ignition is inactive, the sunshade cannot be moved by the sunshade switch.
-
If the ignition goes inactive during window or sunshade movement after the Initialization or Teach Procedure, the window lamella and/or sunshade
will stop.
Sunroof Motor/Actuator Replacement (With RPO Code CF5)
SUNROOF MOTOR/ACTUATOR REPLACEMENT (WITH RPO CODE CF5)
REMOVAL PROCEDURE
1. Remove the headliner.
IMPORTANT: The sunroof actuator drive shaft turns in both directions and contains no limit switches. You may replace the sunroof motor/actuator
with the window panel in any position.
2. Disconnect the electrical connector from the motor/actuator.
