G6 V6-3.9L VIN 1 (2006)
Housing Assembly HVAC: Service and Repair
HVAC MODULE ASSEMBLY REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument panel (I/P) assembly.
2. Remove the recirculation actuator wire harness connector.
3. Remove the air temperature actuator wire harness connector.
4. Remove the mode actuator wire harness connector.
5. Remove the blower motor wire harness connector.
6. Remove the blower motor resistor wire harness connector.
7. Remove the left hand side window defogger outlet duct.
8. Remove the lower floor duct push-in fastener.