G6 V6-3.9L VIN 1 (2006)
4. Install the heater inlet and outlet pipe bracket to the throttle body studs.
5. Install the heater inlet and outlet hoses to the heater pipes.
6. Position the heater inlet and outlet hose clamps (2, 3) at the heater pipes.
7. Install the heater inlet and outlet pipe nuts (1).
Tighten the nuts to 10 N.m (89 lb in).
8. Connect the ETC electrical connector (2).
9. Fill the cooling system. Refer to Draining and Filling Cooling System. See: Engine, Cooling and Exhaust/Cooling System/Service and Repair
10. Install the air cleaner outlet duct.
11. Install the intake manifold cover.
