G6 V6-3.9L VIN 1 (2006)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor Replacement
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the power steering pump.
2. Disconnect the camshaft position (CMP) sensor electrical connector.
3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.
5. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.
INSTALLATION PROCEDURE
1. Replace the O-ring if damaged, lubricate the NEW O-ring with clean engine oil.