G6 V6-3.9L VIN 1 (2006)
Vehicle Speed Sensor: Service and Repair
4T45-E - Automatic Transaxle
Vehicle Speed Sensor (VSS) Replacement
Removal Procedure
1. Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a
hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
Position the vehicle on a hoist and raise the vehicle.
2. Disconnect the electrical connector.
3. Remove the output speed sensor stud.
4. Remove the output speed sensor from the transaxle case.
5. Important: Inspect the O-ring for damage and replace if necessary.
Remove the O-ring from the output speed sensor.
Installation Procedure
1. Install the O-ring onto the output speed sensor.
2. Install the output speed sensor into the transaxle case.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the output speed sensor stud.
Tighten the speed sensor stud to 11 Nm (8 ft. lbs.).
4. Connect the electrical connector.