G6 V6-3.9L VIN 1 (2006)
GMLAN WIRING REPAIRS
TOOLS REQUIRED
J-38125 Terminal Repair Kit
The GM Local Area Network (GMLAN) System requires special wiring repair procedures due to the sensitive nature of the circuitry. Follow the
specific procedures and instructions when working on GMLAN connectors and terminals.
The tool kit J-38125 contains the following items in order to repair the GMLAN wiring:
-
Duraseal splice sleeves
-
A wire stripping tool
-
J 38125-8 Crimping Tool (GM P/N 12085115)
-
J 38125-5 Ultra Torch Special Tool (GM P/N 12085116)
The duraseal splice sleeves have the following 2 critical features:
-
A special heat shrink sleeve environmentally seals the splice. The heat shrink sleeve contains a sealing adhesive inside.
-
A cross hatched (knurled) core crimp provides necessary contact integrity for the sensitive, low energy circuits.
The J-38125 also serves as a generic terminal repair kit. The kit contains the following items:
-
A large sampling of common electrical terminals
-
The correct tools in order to attach the terminals to the wires
-
The correct tools in order to remove the terminals from the connectors
GMLAN REPAIRS
IMPORTANT: When making a repair to any GMLAN network, the original wire length after the repair must be the same length as before the repair.
If the network is a twisted pair, the twist must be maintained after the repair is completed.
GMLAN has 2 types of networks, low speed and high speed. Low speed GMLAN has a single wire and works at slow speeds. High speed GMLAN
has 2 wires in a twisted pair and works at higher speeds. For more information on GMLAN, refer to Data Link Communications Description and
Operation.
GMLAN CONNECTOR TERMINAL REPAIR
IMPORTANT: A service terminal can be used to replace damaged connector terminals for both high speed and low speed GMLAN systems. When
making a connector terminal repair on a GMLAN high speed system with twisted pair wires, do not untwist the wires more than necessary to make the
repair.
The terminals in the GMLAN system are made of a special metal. This metal provides the necessary contact integrity for the sensitive, low energy
circuits. These terminals are available in the J-38125. If the individual terminals are damaged on any GMLAN connection, use the appropriate
connector repair procedure in order to repair the terminal. Refer to Connector Repairs for the appropriate connector repair procedure.
GMLAN WIRE REPAIR
IMPORTANT: Refer to Wiring Repairs in order to determine the correct wire size for the circuit you are repairing. You must obtain this information
in order to ensure circuit integrity.
If a wire is damaged, repair the wire by splicing in a new section of wire of the same gage size (0.5 mm, 0.8 mm, 1.0 mm, etc.). Use the duraseal
