G6 V6-3.9L VIN 1 (2006)
15. Remove the power steering gear outlet pipe routing pin-style retainer from the RH rear side of the cradle/frame.
Important: Convertible vehicles utilize a cross brace that is installed by sharing the cradle/frame mounting bolts. With the rear cradle frame bolts
removed, it allows the cross brace to have movement to gain access to the power steering gear mounting bolts.
16. Convertible vehicles, support the rear of the cradle/frame with a suitable jack stand.
17. Convertible vehicles, remove the rear cradle/frame mount bolts.
18. Remove the power steering gear mounting bolts, nuts, and washers from the gear.
Important: The power steering gear will need to be rotated while it is removed through the LH wheel opening.
19. Remove the power steering gear through the LH wheel opening.
20. If the power steering gear is to be replaced, transfer the outer tie rod ends to the new steering gear.
Installation Procedure
Important: The power steering gear will need to be rotated while it is installed through the LH wheel opening.
1. Position the power steering gear into the vehicle.
2. Connect the intermediate steering shaft to the steering gear.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
