G6 V6-3.9L VIN 1 (2006)
1. Loosen the adjuster plug lock nut (1).
2. Turn the adjuster plug clockwise until the adjuster plug bottoms in the gear assembly.
3. Turn the adjuster plug back 50 degrees to 70 degrees (approximately one flat).
4. Notice: Refer to Fastener Notice.
Install the adjuster plug lock nut (1) to the adjuster plug.
Hold the adjuster plug stationary while tightening the adjuster plug lock nut (1) to 68 Nm (50 ft. lbs.).
Rack and Pinion Inner Tie Rod Replacement - Off Vehicle (Magnasteer)
Rack and Pinion Inner Tie Rod Replacement - Off Vehicle (Magnasteer)
Tools Required
^
J34028 Inner Tie Rod Wrench
Disassembly Procedure
1. To remove the rack and pinion boot, refer to Rack and Pinion Boot and Breather Tube Replacement - Off Vehicle.
2. Place the gear in a vise.
3. Notice: Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear
preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.
Remove the shock dampener (6) from the inner tie rod housing (4).
4. Slide the shock dampener (6) back on the rack (5).
5. Notice: The pipe wrench must be placed at the valve end of the steering gear and positioned up against the inner tie rod housing. Placing the pipe
wrench in any other location will cause damage to the steering gear.
Place a pipe wrench on the rack (5) next to the inner tie rod housing (4).
6. Place a wrench on the flats of the inner tie rod housing (4).
7. Rotate the inner tie rod housing (4) counterclockwise, while holding the rack stationary, until the inner tie rod separates from the rack (5).
