G6 V6-3.9L VIN 1 (2006)
23. Remove the radiator and condenser support and the engine support fixture.
24. Install the upper transmission to engine bolts and stud.
Tighten the bolts/stud to 90 Nm (66 ft. lbs.).
25. Install the shift cable bracket and shift cable to the lever.
26. Install the exhaust pipe upper bolts and heat shield.
27. Connect the electrical connectors to the PNP switch and transaxle.
28. Connect the negative battery cable.
29. Install the air intake duct.
30. Add automatic transmission fluid (ATF) and verify the proper fluid level of the transaxle.
31. Road test the vehicle.
