G6 V6-3.9L VIN 1 (2006)
Seals and Gaskets: Service and Repair
4T45-E - Automatic Transaxle
Case Side Cover Seal Replacement
Case Side Cover Seal Replacement
Tools Required
^
J41227 Output Shaft Sleeve Remover
^
J41228 Output Shaft Sleeve Installer
^
J41102 Axle Seal Installer
Removal Procedure
1. Raise the vehicle.
2. Remove the drive axle assembly.
3. Use a medium screwdriver and a mallet in order to remove the case cover seal.
4. Remove the drive axle retaining clip from the output axle.
5. Use the J41227 in order to remove the sleeve from the output axle shaft.
6. Clean and inspect the seal bore.
7. Use fine sand paper in order to remove any burrs or nicks. Clean the entire area after any sanding.
Installation Procedure
