G6 V6-3.9L VIN 1 (2006)
1. Use the J41228 to install a new sleeve on the output axle shaft. Ensure that the collet is located in the snap ring groove when installing.
2. Install the new output axle seal.
3. Install one new snap ring on the output shaft.
4. Install the drive axle assembly.
5. Lower the vehicle.
6. Inspect the output axle shaft sleeve for leaks.
7. Inspect the oil level.
Stub Axle Shaft Sleeve and Seal Replacement
Stub Axle Shaft Sleeve and Seal Replacement
Tools Required
^
J38868 Shaft Removal Tool
^
J6125-1B Slide Hammer
^
J23129 Universal Seal Remover
^
J41102 Axle Seal Installer
Removal Procedure
1. Important: Do not damage the seal bore or the sleeve assembly. Fluid leaks may result.
Raise and support the vehicle. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
2. Remove the drive axle assembly. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.