G6 V6-3.9L VIN 1 (2006)
Disassembly/Assembly Procedure
For step by step instructions on how to disassemble/assemble the control valve body, refer to Control Valve Body Disassemble and Control Valve
Body Assemble in the Transmission/Transaxle Unit Repair.
Installation Procedure
1. Make sure the checkballs are in the proper locations on the channel plate. Retain the checkballs with petroleum jelly.
2. Install a new spacer plate-to-channel plate gasket onto the channel plate.
3. Install the spacer plate with the spacer plate filter attached.
4. Notice: Refer to Fastener Notice in Service Precautions.
Hand start the spacer plate support bolts and install the spacer plate support.
Tighten the spacer plate support bolts to 14 Nm (10 ft. lbs.).