G8 V6-3.6L (2008)
Notice: Refer to Component Fastener Tightening Notice (See: Service Precautions/Vehicle Damage Warnings/Component Fastener Tightening
Notice) .
Important: New oxygen sensors should have a special anti-seize compound already applied to the sensor threads. If you are installing the
original sensor, apply an approved anti-seize compound to the sensor threads.
1. Install the HO2S to the catalytic converter.
Tighten the HO2S to 40 N.m (30 lb ft).
2. Install the catalytic converter to the vehicle. Refer to Catalytic Converter Replacement - Right Side (6.0L Engine) (See: Emission Control
Systems/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Right Side (6.0L Engine))Catalytic Converter Replacement -
Right Side (3.6L Engine) (See: Emission Control Systems/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Right Side
(3.6L Engine)) .
