G8 V6-3.6L (2008)
Accelerator Pedal Position Sensor: Service and Repair
Accelerator Pedal Position Sensor Replacement
Removal Procedure
1. Remove the closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (LHD) (See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair) .
Notice: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic
throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control
components in cleaning solvents of any type.
2. Disconnect the accelerator pedal position (APP) sensor electrical connector (1).
3. Remove the APP sensor to vehicle retaining screws (2).
4. Remove the APP sensor (3) from the vehicle.
Installation Procedure
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
1. Install the APP sensor (3) to the vehicle.
Tighten the APP sensor bracket screws (2) to 9 N.m (80 lb in).
2. Connect the APP sensor electrical connector (1).
3. Operate the accelerator pedal and observe the APP angles using a scan tool. The accelerator pedal should operate freely, without binding between
closed throttle and wide open throttle.
4. Install the closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (LHD) (See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair) .
