G8 V6-3.6L (2008)
Important: Align the mark from bolt to upper control arm made prior to removal.
Important: The weight of the vehicle must be on a level surface and on all four wheels before fully tightening the nuts and bolts.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
7. Tighten the upper control arm to knuckle retaining bolt (2) and NEW nut (1).
Tighten the bolt and nut to 60 N.m(44 lb ft).
Tighten the bolt and nut to 90 Degrees.
8. Check the vehicle rear wheel alignment and adjust if necessary. Refer to Wheel Alignment Specifications (See: Alignment/Specifications) .
Knuckle Bushing Replacement - Lower
Knuckle Bushing Replacement - Lower
Tools Required
KM-619 Bushing Remover/Installer.
Removal Procedure
Caution: Refer to Safety Glasses Caution (See: Service Precautions/Technician Safety Information/Safety Glasses Warning) .
Caution: Refer to Vehicle Lifting Caution (See: Wheels and Tires/Vehicle Lifting/Service Precautions) .
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair) .
2. Remove the rear wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
3. Support the lower control arm with a suitable jack.
