G8 V6-3.6L (2008)
1. Install the power steering fluid reservoir outlet hose worm drive clamps (1) and (4) to power steering fluid reservoir outlet pipe/hose (3).
2. Remove the plug from the power steering pump (2).
3. Install the fluid reservoir outlet hose (3) to the power steering pump (2).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Tighten the power steering fluid reservoir outlet hose worm drive clamp (1).
Tighten the worm drive clamp.
5. Remove the plug from the power steering fluid reservoir (5).
6. Connect the fluid reservoir outlet hose (3) to the power steering fluid reservoir (5).
7. Tighten the power steering fluid reservoir outlet hose worm drive clamp (4).
Tighten the worm drive clamp.
Notice: When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will
cause hose and seal damage and fluid leaks.
8. Fill power steering fluid reservoir with fluid to the MAX level mark on the reservoir.
9. Bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair) .
10. Check for power steering fluid leaks.
11. Remove the container from under the vehicle.
12. Install the engine dress cover. Refer to Engine Cover Replacement (See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Cover Replacement) .
Power Steering Gear Inlet Pipe/Hose Replacement (3.6L Engine)
Power Steering Gear Inlet Pipe/Hose Replacement (3.6L Engine)
Removal Procedure
