G8 V6-3.6L (2008)
Important: The NEW outer joint boot (1) must not be dimpled, stretched, or deformed. Always equalise the air pressure in the NEW
outer joint boot with the joint in the centre of its plunge position and shape properly by hand.
6. The outer constant velocity joint dimension A is 248 mm (9.8 in) for V6 and 254.3 mm (10 in) for V8.
7. Fully cycle the outer constant velocity joint several times to disperse grease throughout the outer constant velocity joint.
8. Install the inner constant velocity joint and joint boot. Refer to Wheel Drive Shaft Inner Joint and Boot Replacement (See: Constant Velocity
Joint/Service and Repair/Wheel Drive Shaft Inner Joint and Boot Replacement) .
9. Install the wheel drive shaft to the vehicle. Refer to Wheel Drive Shaft Replacement (See: Service and Repair) .
10. Remove the safety stands.
11. Lower the vehicle to the ground.
