Grand AM L4-138 2.3L DOHC VIN D MFI (1994)
NOTE
Do NOT wipe grease from module or coil if same module is to be replaced. If a new module is to be installed, a package of silicone grease will be
included with it. Spread the grease on the metal face of the module and on the cover where the module seats. This grease is necessary for module
cooling.
Dielectric Grease Application
INSTALLATION
1. Install module to cover.
2. Install module to cover screws (3). Torque to 4 N-m (35 lb.in.).
3. Connect coil harness connector to module.
4. Install housing to cover.
5. Install housing to cover screws (4). Torque to 4 N-m (35 lb.in.) .
6. Connect spark plug boots and retainers to housing.
7. Install ignition system assembly to engine while carfully aligning boots to spark plug terminals.
8. Install ignition system assembly to cam housing bolts after coating threads with 1052080 or equivalent (4). Torque to 26 N-m (19 lb ft).
9. Connect 11 pin IDI harness connector.
10. Connect negative battery cable.
