Grand AM L4-138 2.3L DOHC VIN D MFI (1994)
1. Install new boot clamp onto boot.
2. Apply grease to inner tie rod or housing as shown in Fig. 16.
3. Align and install breather tube.
4. Install boot onto housing until seated in housing groove tang.
5. Position boot clamp on boot and crimp.
6. Position tie rod end clamp on boot and secure with pliers.
Pinion and Valve Assembly
Fig. 34 Pinion & Valve Assembly
REMOVAL
1. Turn stub shaft until rack guide is equal distance from both sides of housing opening, then mark location of stub shaft notch on housing, Fig. 34.
2. Using a suitable press, press on threaded end of pinion until it is possible to remove valve and pinion assembly from housing.
3. Replace valve body rings if necessary.
Rack Bearing Preload
ON VEHICLE ADJUSTMENT
Make adjustment with front wheels raised and steering wheel centered. Ensure the steering wheel returns to the center position after adjustment.
1. Loosen locknut, then turn adjuster plug clockwise until it bottoms in housing, then back off 35 ° to 45 °.
2. Torque locknut to adjuster plug to 50 ft. lbs. while holding adjuster plug.
Pinion Bearing Assembly