Grand AM L4-138 2.3L VIN A MFI (1992)
Ignition Coil And Module Assembly
16. Locate the ignition coil and module assembly over the spark plugs and push straight down.
-
Clean Any lubricant that is present on the ignition coil and module assembly to cam housing bolts.
17. Apply Pipe Sealant GM P/N 1052080 or equivalent onto the ignition coil and module assembly to camshaft housing bolts.
NOTE: Hand start the ignition coil and module assembly to cam housing bolts.
18. Tighten bolts to 22 Nm (16 lbs. ft.).
19. Electrical connector to ignition coil and module assembly.
20. Negative battery cable.
21. Start engine.
NOTE: If new lifters have been installed or the lifters bled down while engine was disassembled, excessive lifter noise may be experienced. This
is a normal condition, no engine damage is occurring. Use the following procedure to purge the air from the lifters:
-
Start engine and allow to warm up at idle for 5 minutes.
-
Increase engine speed to 2000 rpm until the lifter noise is gone.
-
Return engine to idle for an additional 5 minutes or road test.
22. Inspect For oil leaks. Add oil, if required.
Manual Transmission
INSTALL OR CONNECT
