Grand AM L4-144 2.4L DOHC VIN T SFI (1997)
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor Wiring
NOTE: The front wheel speed sensor wiring is subjected to the same motion. As a spring or shock absorber. Consequently, any repair to the front wheel
speed sensor wiring circuits in the control arm section of the wiring harness will result in stiffening and eventual failure due to wire fatigue. For this
reason, The front wheel speed sensor wiring is not repairable in the control arm section of the wiring harness. This section of the wiring harness must be
replaced with the appropriate wiring harness service kit "pigtail." The splice must be located within the main branch of the engine harness. Do not
attempt to solder, splice, or crimp this section of the wiring harnesses as eventual failure will likely result.
REMOVE OR DISCONNECT
1. Connector from wheel speed sensor.
2. Harness attaching clips for control arm and splash shield.
3. Lower vehicle.
4. Harness attaching clips from strut tower.
5. Cut wheel speed sensor wiring circuits within main engine harness.
6. Strip insulation on engine harness leads and new wheel speed sensor harness leads.
