Grand AM L4-144 2.4L DOHC VIN T SFI (1997)
9. Pull and hold cable towards the rear of the car to create slack in cable.
10. Cable from equalizer and conduit fitting from axle bracket
11. Tire, wheel and brake drum.
12. Insert screwdriver between brake shoe and lower part of brake adjuster bracket.
13. Cable eyelet fitting from rear park brake lever.
14. Conduit fitting from backing plate while depressing conduit fitting retaining tangs.
INSTALL OR CONNECT
1. Conduit fitting into backing plate.
2. Parking brake cable to parking brake lever in drum assembly.
3. Brake drum, tire and wheel assembly.
4. Conduit fitting retaining tangs and conduit fitting into axle bracket.
5. Cable to equalizer.
6. Cable to connector.
7. Lower vehicle.
8. Console, (and shifter boot).
9. Fully apply and release hand brake 4-6 times to self adjust system.
10. Check parking brake tension.
NOTE: Parking brake adjustment is not necessary. This is a self adjusting system and damage may result from attempting to adjust or modify this
system in any way. It may be necessary to adjust rear brakes to obtain the proper tension in the. system.
