Grand AM L4-144 2.4L DOHC VIN T SFI (1997)
Cruise Control Switch: Adjustments
The release switch assembly and the stoplamp switch assembly cannot be adjusted until after the brake booster pushrod is assembled to the brake pedal
assembly. The cruise control release switch and the stoplamp switch are adjusted together. Incorrect adjustment could cause the cruise control system to
not work properly.
Adjust
1. Press brake pedal assembly and insert switch assembly and stoplamp switch assembly into retainers until fully seated.
2. Slowly release brake pedal assembly back to its fully retracted position. The release switch assembly will move within retainers to their
"adjusted" position.
Important
The following brake pedal assembly travel distances can be used to check for properly adjusted release switch assembly and stoplamp switch
assembly.
^
Release switch assembly and stoplamp switch assembly contacts must be open at 3.5 to 12.5 mm (1/8 to 1/2 inch) brake pedal assembly
travel, measured at the centerline of the brake pedal assembly pad. Nominal actuation of the stoplamp switch assembly contacts is about 4.5
mm (3/16 inch) after cruise control switch assembly contacts close.
