Grand AM L4-144 2.4L DOHC VIN T SFI (1997)
Coolant Temperature Sensor/Switch (For Computer): Description and Operation
Description
Notice: Numbers in text correspond to numbered components in image.
The Engine Coolant Temperature (ECT) sensor (3) is a thermistor (a resistor which changes value based on temperature) mounted in the engine coolant
stream. Low coolant temperature produces a high resistance (100,000 ohms at -40°C/-40°F), while high temperature causes low resistance (70 ohms at
130°C/266°F).
Operation
The PCM supplies a 5 volt signal to the ECT sensor through a resistor in the PCM and monitors the terminal voltage. Since this forms a series circuit to
ground through the ECT sensor, high sensor resistance (low temperature) will result in high PCM terminal voltage. When the resistance of the ECT
sensor is low (high temperature), the terminal voltage will be drawn lower. This terminal voltage indicates engine coolant temperature to the PCM.
Circuit Faults
A hard fault in the ECT sensor circuit should set either a DTC P0117 or P0118. Remember, these DTCs indicate a malfunction in the engine coolant
temperature circuit, so proper use of the DTC table may lead to either repairing a wiring problem or replacing the sensor, to properly repair a problem.
