Grand AM L4-144 2.4L DOHC VIN T SFI (1997)
11. Remove the intake manifold retaining nuts and bolts.
12. Remove the intake manifold and the gasket.
INSTALLATION
NOTE: The engine and the manifold should be at ambient temperature when assembled. Do not attempt to install a cold manifold on a hot
engine.
1. Install the intake manifold and the gasket. If the gasket is damaged, install a new one with the stamped numbers facing towards the manifold
surface.
2. Install the intake manifold fasteners. Tighten the fasteners to 24 Nm (18 lb ft).
3. Raise and suitably support the vehicle.
4. Install the intake manifold brace. Finger start all bolts.
a. Tighten bolt (A) to 24 Nm (18 lb ft).
b. Tighten bolt (B) to 26 Nm (19 lb ft).
5. Lower the vehicle.
6. Connect the EGR pipe to the EGR adapter.
7. Install the EGR pipe to the EGR adapter fasteners. Tighten the fasteners to 26 Nm (19 lb ft).
8. Install the stud ended generator mount bolt.
9. Install the accelerator control cable bracket.
10. Connect the vacuum hoses to the fuel regulator and to the EVAP canister purge solenoid.
NOTE: If the IAT sensor is removed, apply sealant GM P/N 1052080 or equivalent to its threads before installation.
11. Connect the following electrical connections:
^
Manifold absolute pressure sensor.
^
IAT sensor.
^
EVAP canister purge solenoid.
^
Fuel injector harness.
12. Install the air cleaner duct.
13. Connect the negative battery cable.
