Grand AM V6-3.4L VIN E (2001)
5. Remove the left carpet retainers.
6. Remove the lower center pillar trim panel.
7. Adjust the carpet for access to the wiring harness as required.
8. Remove the left instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges and Warning
Indicators.
9. Adjust the radio for access. Disconnect the antenna coaxial cable from the rear of the radio. Refer to Radio Replacement
10. Cut off the visible end of the coaxial antenna cable from the wiring harness in the kick panel area.
11. Cut off the visible end of the coaxial antenna cable from the wiring harness in the rear shelf area.
INSTALLATION PROCEDURE
1. Install the coaxial antenna cables to the vehicle. Use electrical tape in order to secure the antenna extension cable to the top of the wiring harness.
Make sure that the cable is secured to the harness at least every 150 mm (6 in).
2. Connect the coaxial antenna cable to the rear of the radio. Install the radio. Refer to Radio replacement
IMPORTANT: The antenna coaxial cable uses a sliding snap-lock. Holding the sliding lock feature will prevent installation.
