Grand AM V6-3.4L VIN E (2001)
3.
Remove the adhesive with a one edge razor blade.
4.
Clean the glass with Isopropyl alcohol.
Important:
Install adhesive into the applicator and squeeze some adhesive out before you install the mixing tube. After the mixing tube is installed, run a
test bead the length of the mixing tube to ensure a good mix.
5.
Fill the sash channel clip with adhesive.
6.
Install the clip in the marked location.
7.
Reinstall the door glass and put the glass in the full up position for 24 hours.
Sash Channel Damaged
1.
Mark the edge of the clip for location.
2.
Cut off the bottom edge of the guide with a cut off wheel. (Refer to the illustration above.)
3.
Using a thin flat blade putty knife and a hammer, carefully remove the plastic piece on each side of the glass. (Refer to the illustration above).
4.
Clean any adhesive from the glass using a one-edge razor blade. (Refer to the illustration above).
5.
Clean the glass with Isopropyl alcohol.
Important:
Install adhesive into the applicator and squeeze some adhesive out before you install the mixing tube. After the mixing tube is installed, run a
test bead the length of the mixing tube to ensure a good mix.
