Grand AM V6-3.4L VIN E (2001)
Front Door Window Regulator: Customer Interest
Body - Door Glass Sash Comes Out Of Run Channel
TECHNICAL
Bulletin No.: 01-08-64-012F
Date: September 22, 2008
Subject:
Door Glass Sash Out of Run Channel (Repair Door Glass Sash Channel)
Models:
1999-2004 Oldsmobile Alero
1999-2005 Pontiac Grand Am
Supercede:
This bulletin is being revised to update the applicator P/N in the Parts Information section. Please discard Corporate Bulletin Number 01-08-64-012E
(Section 08 - Body & Accessories).
Condition
Some customers may comment that the door glass is out of the channel.
Cause
The door glass sash channel may have come off the glass or the sash channel clip may be damaged.
Correction
Caution:
When working with any type of glass, use approved safety glasses and gloves to reduce the chance of personal injury.
Important:
If the clip location is unknown, install the glass in the full up position and attach the new clip to the regulator and power the regulator to the
full up position. This will set the clip in the proper position so you can mark its location.
Replace the sash channel following the repairs listed below.
Sash Channel Came Off Glass; Adhesive on Glass
1.
Remove the door glass and lay it on a protected table.
2.
Mark the location of the clip with tape.
3.
Remove the adhesive with a one edge razor blade.
4.
Clean the glass with Isopropyl alcohol.
Important:
Install adhesive into the applicator and squeeze some adhesive out before you install the mixing tube. After the mixing tube is installed, run a
test bead the length of the mixing tube to ensure a good mix.
5.
Fill the sash channel clip with adhesive.
6.
Install the clip in the marked location.
7.
Reinstall the door glass and put the glass in the full up position for 24 hours.
Sash Channel Damaged
1.
Mark the edge of the clip for location.
