Grand AM V6-3.4L VIN E (2001)
3. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
*
Dimension (A) 70 mm (2 3/4 in) from the front edge headlamp seal to the emblem.
*
Dimension (B) 28 mm (1 1/8 in) is the distance bottom edge of the fender and the emblem.
4. Heat the mounting surface to approximately 27-41°C (80-105°F).
5. Ensure that the temperature of the emblem/name plate is approximately 29-32°C (85-90°F).
6. Remove the protective liner from the back of the emblem/name plate.
7. Position the emblem/name plate to the location marks and press the emblem/name plate to the mounting surface.
8. Apply equal pressure along the emblem/name plate in order to uniformly bond the item to the mounting surface.
9. Remove the protective tape from the mounting surface.
Exterior Trim Molding/Nameplate Replacement
Exterior Trim Molding/Nameplate Replacement
The body side moldings and the emblems attach to the body panels with adhesive tape. The moldings and the emblems require preparation prior to
replacement. In order to properly replace the molding or the emblem, ensure that the panel surface meets the following conditions:
*
Warm, 21-32°C (70-90°F)
*
Clean
*
Free of any wax or oily film
