Grand AM V6-3.4L VIN E (2001)
25.
Re-install the garment hooks.
26.
Properly position the rear seat shoulder harness retractor and install the bolt.
Tighten
Tighten the bolt to 36 Nm (27 lb ft).
27.
Re-install both lower rear quarter trim panels.
28.
Re-install the rear seat side bolsters/back rest assembly.
29.
Re-install the seatback/side bolster retainers.
Tighten
Tighten the retainers to 12 Nm (106 lb in).
30.
Re-install the rear seat cushion into the vehicle and properly secure it into place.
31.
Re-install the carpet retainers in both front door areas.
32.
Proceed to Vehicle Configuration, in this bulletin.
Vehicle Configuration
The following steps must be performed to configure the vehicle and allow the theft deterrent system to recognize the vehicle.
1.
Re-connect the negative battery cable. Tighten
Tighten the cable retainer to 15 Nm (11 lb ft).
2.
Re-connect the Tech 2 to the ALDL connector.
3.
Turn the key to the RUN position, engine OFF.
4.
Select Remote Function Actuation.
5.
Select Special Functions.
6.
Select Program Key Fobs.
7.
Select the number of key fobs to be programmed.
8.
Press and hold the LOCK and UNLOCK buttons simultaneously on the first transmitter for approximately 15 seconds. The power locks should
cycle to confirm programing of the first transmitter is complete.
9.
Repeat the previous step for all other transmitters issued with the vehicle.
10.
Exit out to the main screen of the Tech 2.
11.
Turn the key to the Off position. Disconnect the Tech 2 and wait 30 seconds.
12.
Re-connect the Tech 2 to the ALDL.
13.
Turn the key to the ON position.
14.
Power on the scan tool and enter the main menu.
15.
From the main menu, select Diagnostics.
16.
Select 2001 for the model year.
17.
With correct passenger car highlighted, press enter.
