Grand AM V6-3.4L VIN E (2001)
6. Push down the lock tab (1) and then move the sliding connector cover back in the home position to lock.
7. Insert the CPA (2) back into place.
8. Install the left engine splash shield.
9. Install the front engine splash shield.
10. Lower the vehicle. Refer to Vehicle Lifting.
Caution: Make sure brake pipes correctly connected to brake pressure modulator valve. If brake pipes are switched by mistake, wheel
lockup will occur and personal injury may result. The only two ways this condition can be detected are by using a Scan Tool or by doing an
Antilock stop.
11. Connect the master cylinder brake pipes (1) to the BPMV (3).
^
Tighten the brake pipe fittings to 24 Nm (18 ft. lbs.).
12. Connect the caliper and wheel cylinder brake pipes (2) to the BPMV (3).
^
Tighten the brake pipe fittings to 24 Nm (18 ft. lbs.).
13. Install the battery tray.
14. Install the battery.
15. Perform the Automated Bleed Procedure.
16. Perform the Diagnostic System Check - ABS.
