Grand AM V6-3.4L VIN E (2001)
1. Lubricate the new piston seal (4) with Delco Supreme 11(R) (GM P/N 12377967) or equivalent DOT-3 brake fluid from a clean, sealed brake
fluid container.
2. Install the lubricated, new piston seal (4) into the caliper bore.
3. Install the caliper piston (3) into the caliper bore.
4. Install the new caliper dust boot seal (2).
5. Install the bleeder valve (5) and cap (6) to the caliper and tighten the valve securely.
6. Install the front brake caliper to the vehicle. Refer to Brake Caliper Replacement - Front.
Rear
Brake Caliper Overhaul - Rear
Removal Procedure
1. Remove the rear brake caliper from the vehicle. Refer to Brake Caliper Replacement- Rear.
2. Remove the brake caliper piston from the caliper bore by directing low pressure compressed air into the caliper bore through the fluid inlet hole.
