Grand AM V6-3.4L VIN E (2001)
Water Pump: Service and Repair
WATER PUMP REPLACEMENT
Removal Procedure
1. Drain the cooling system.
2. Loosen the water pump pulley bolts.
3. Remove the drive belt.
4. Remove the water pump pulley bolts and pulley.
5. Remove the water pump bolts, pump and gasket.
6. Clean the water pump mating surfaces.
Installation Procedure
1. Install the water pump gasket and pump (1).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the water pump bolts.
Tighten the water pump bolts to 10 Nm (89 inch lbs.).