Grand AM V6-3.4L VIN E (2001)
Compressor Shaft Seal: Service and Repair
Compressor Shaft Seal Removal
TOOLS REQUIRED
^
J 41790 Compressor Holding Tool
^
J 42136 A/C Lip Seal Remover
1. Place the compressor on the J 41790.
2. Remove the compressor clutch plate and hub assembly. Refer to Compressor Shaft Seal Removal (V5 - Direct Mount).
3. Remove the compressor shaft seal retainer ring (2), using internal snap ring pliers (1).
4. To keep any dirt or foreign material from getting into the compressor, thoroughly clean the following components:
^
The inside of the compressor neck area surrounding the shaft
^
The exposed portion of the compressor shaft seal
^
The compressor shaft
^
The O-ring groove
