Grand AM V6-3.4L VIN E (2001)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Remove the power steering pump.
3. Disconnect the sensor electrical connector.
4. Remove the attaching bolt.
5. Remove the sensor.
6. Inspect the sensor O-ring for wear, cracks or leakage if the sensor is not being replaced.
INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil. Replace the O-ring if the O-ring is damaged.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the camshaft position sensor.
Tighten
Tighten the retaining bolt to 8 N.m (71 lb ft).
3. Connect the sensor electrical connector.
4. Install the power steering pump.
