Grand AM V6-3.4L VIN E (2001)
Band Apply Servo: Service and Repair
Low/Reverse Servo Assembly Replacement
Low/Reverse Servo Assembly Replacement
Removal Procedure
Caution: Refer to Vehicle Lifting Caution in Service Precautions.
1. Raise the vehicle. Support the vehicle.
2. Remove the oil pan and filter.
3. Remove the oil feed pipes.
4. Remove the three lo and the reverse band servo cover bolts, the servo and the spring.
5. Disassemble, clean and inspect the lo/reverse servo assembly.
Installation Procedure
1. Assemble the lo/reverse servo.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the lo and the reverse band servo cover bolts.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
3. Install the oil feed pipe.
4. Install the oil filter and pan.
5. Lower the vehicle.
6. Connect the negative battery cable.
7. Fill the transmission.
8. Inspect the transmission fluid level.
