Grand AM V6-3.4L VIN E (2001)
Tighten
Tighten the four (4) bolts to 25 Nm (18 lb ft).
55.
Reinstall the relay and fuse center in the bracket. Be sure it is properly snapped into place.
56.
Position the clutch master cylinder line into the bracket on the relay and air cleaner bracket.
57.
Reinstall the air cleaner assembly.
58.
Raise the vehicle on the hoist.
59.
Reinstall the specified bolt. Refer to Figure 10.
60.
Reinstall the left front fender inner closeout panels.
61.
Reinstall the left front tire and wheel assembly using the proper star pattern and the torque stick for tightening the lug nuts.
62.
Lower the vehicle.
63.
From inside the vehicle, close and lock the locking tabs for the shifter cables adjusters.
