pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Recall - M/T Shifter Non/Compliance|Page 6688 > < Recall - M/T Shifter Non/Compliance|Page 6686
Page 4
background image

ALL

All unsold new vehicles in dealers1 possession and subject to this campaign MUST be held and inspected/repaired per the service procedure of this
campaign bulletin BEFORE customers take possession of these vehicles.

Dealers are to service all vehicles subject to this campaign at no charge to customers, regardless of mileage, age of vehicle, or ownership, from this time
forward.

Customers who have recently purchased vehicles sold from your vehicle inventory, and for which there is no customer information indicated on the
dealer listing, are to be contacted by the dealer. Arrangements are to be made to make the required correction according to the instructions contained in
this bulletin. This could be done by mailing to such customers a copy of the customer letter shown in this bulletin. Campaign follow-up cards should not
be used for this purpose, since the customer may not as yet have received the notification letter.

In summary, whenever a vehicle subject to this campaign enters your vehicle inventory, or is in your dealership for service in the future, please take the
steps necessary to be sure the campaign correction has been made before selling or releasing the vehicle.

Disclaimer

Service Procedure

1.

Prep the vehicle. Place the vehicle in the repair stall over a hoist, place blocks in front of and behind the front tires.

2.

Place the transaxle shifter in the Neutral position.

3.

Position the driver and passenger seat assemblies in the full rearward position.

4.

Hook up both seat belts (connect the belt to the buckle).

5.

Remove the battery from the vehicle.

6.

Remove the air cleaner assembly.

7.

Remove the clutch master cylinder hose from its bracket, just below the underhood fuse and relay center.

8.

Raise the vehicle on the hoist.

9.

Depress the locking tab on the underhood fuse and relay bracket and slide the relay center toward the front of the vehicle.

10.

Remove the left front tire and wheel assembly.

11.

Remove the left front fender inner closeout panels.

Recall - M/T Shifter Non/Compliance|Page 6688 > < Recall - M/T Shifter Non/Compliance|Page 6686