Grand AM V6-3.4L VIN E (2001)
Front Door Window Regulator: Service and Repair
Door Window Regulator Replacement (Power)
Front Side Door Window Regulator Replacement (Power)
Removal Procedure
1. Lower the window to the down position.
2. Remove the door trim panel.
3. Remove the door water deflector.
4. Remove the window to regulator bolts.
5. Push the window to its full up position and tape in place.
6. Remove the nuts from the regulator cover plate.
7. Remove the regulator drive cable from the rear of the cover plate and remove the cover plate from the door.
8. Disconnect the electric connector to the motor.
9. Remove the regulator bolts (1, 2, 3).
10. Pivot the regulator (right door clockwise, left door counterclockwise) and slide the assembly out of the door.
11. Remove the regulator from the vehicle.
Installation Procedure
1. Partially install the three bolts (2) to hang the regulator in the door.