Grand AM V6-3100 3.1L MFI VIN M (1994)
18. Power steering mounting bolts (support pump aside).
19. Coolant inlet pipe from coolant outlet housing.
20. Coolant by-pass at coolant pump and cylinder head.
21. Radiator hose at coolant outlet housing.
22. Coolant outlet housing.
23. Both valve rocker cover.
24. Lower intake manifold bolts.
IMPORTANT
^
Retain washers in same orientation on center bolts.
25. Loosen rocker arms.
26. Pushrods.
IMPORTANT
^
Place pushrods in order so they can be installed in their original position.
27. Intake gasket.
INSPECT
^
Flatness of inlet flanges.
CLEAN
^
Gasket material from mating surfaces.
^
Excess RTV sealant from front and rear ridges of cylinder block.
^
Sealing surfaces with degreaser.
INSTALL OR CONNECT
1. Place a 2-3 mm bead of GM RTV sealer P/N 1052917 or equivalent on each ridge where the front and rear of the intake manifold contact the
block.
2. Intake manifold gasket.
3. Pushrods.
^
Install pushrods in their original location.
^
Coat the ends of the pushrods with prelube GM P/N 1052356.
^
Intake pushrods are marked red and are 5-3/4 inches long.
^
Exhaust pushrods are marked blue and are 6 inches long.
^
Make sure pushrods seat in lifter.
4. Rocker arm nuts. Tighten rocker arm nuts to 24 Nm (18 lb. ft.).
5. Lower intake manifold.
6. Lower intake manifold bolts. Tighten the vertical bolts first to 13 Nm (115 lb. in.). Tighten the diagonal bolts second to 13 Nm (115 lb. in.).
^
Apply sealant GM P/N 12345739 to threads of bolts.
7. Front valve rocker cover.
8. Coolant outlet housing.
9. Radiator hose to thermostat housing.
10. Coolant inlet pipe to thermostat housing.
11. Coolant by-pass pipe at coolant pump and cylinder head.
12. Power steering pump.
13. Loosely install serpentine belt due to trap design.
14. Right engine mount.
15. Remove engine support fixture, J 28467-A
16. Fuel lines to fuel rail and bracket.
17. Upper intake manifold. Tighten bolts to 25 Nm (18 lb. ft.).
18. MAP sensor.
19. Connect vacuum lines.
^
Vacuum Modulator.
^
Fuel Pressure Regulator.
^
PCV.
20. Engine wiring connectors.
^
TP sensor.
^
IAC.
^
Injector harness.
^
ECT sensor.
^
MAP sensor.
^
CMP sensor.
21. EVAP canister purge solenoid and Electronic ignition coil and module assembly.
22. Generator.
