Grand AM V6-3100 3.1L MFI VIN M (1994)
PCM Location.
REMOVE
-
Disconnect battery ground cable.
-
Right hand kick panel.
-
Disconnect computer electrical connectors.
-
Remove computer mounting hardware.
-
Remove computer from passenger compartment.
-
Remove knock sensor module from PCM (see illustration).
INSTALL
-
Reverse procedure to install.
-
Perform FUNCTIONAL CHECK to verify proper installation.
Data Link Connector (DLC) - Located Underdash
FUNCTIONAL CHECK:
-
Turn the ignition ON.
-
Enter diagnostics.
^
Code 12 should flash. This indicates the PCM is functioning.
NOTE
Disconnecting PCM from it's power source will clear all PCM memories. Since some operations (particularly IAC valve idle control) are
"learned", it may be necessary to partially depress the accelerator pedal when restarting the engine after PCM memory is cleared. It may also
