Grand AM V6-3100 3.1L MFI VIN M (1994)
Discriminating Sensors and Arming Sensors: Technical Service Bulletins
Passenger Discriminating Sensor - Remove and Install
Group Ref.: Accessories
Bulletin No.: 439007
Date: March, 1994
SERVICE MANUAL UPDATE
SUBJECT:
SECTION 9J-74 - REVISED REMOVE/INSTALL PROCEDURE FOR PASSENGER COMPARTMENT DISCRIMINATING SENSOR
MODELS:
1994 BUICK SKYLARK
1994 OLDSMOBILE ACHIEVA
1994 PONTIAC GRAND AM
This bulletin replaces the remove/install procedure for the passenger compartment discriminating sensor located in Section 9J-74 of the Service Manual.
NOTE:
Section 9J, Figure 4, Item 6 (Passenger Compartment Discriminating Sensor) is incorrect. Please refer to Figure 12 in Section 9J for correct location.
PROCEDURE:
The following procedure should be used:
Remove or Disconnect
-
Disable the Supplemental Inflatable Restraint (SIR) system, refer to "Disabling the SIR System" in Section 9J.
1.
Console, refer to Section 8C.
2.
Left and right front seats, refer to Section 10-10.
3.
Floor carpeting partially removed to behind the front seats, refer to Section 10-10.
4.
Rear floor duct or outlet, refer to Section 1A.
5.
Connector Position Assurance (CPA) and sensor lead electrical connection (located near DERM).
6.
Sensor mounting fasteners.
7.
Remove sensor lead wiring and sensor from the vehicle.
Install or Connect
Notice:
Refer to "Notice" on page 9J-1.
1.
Sensor to vehicle, ensure arrow is pointing toward the front of the vehicle.
2.
Sensor mounting fasteners -
TIGHTEN - fasteners to 23.5 N-m (17 lb.ft.)
3.
Route sensor lead wiring.
4.
Sensor lead electrical connection and CPA (located near DERM).
5.
Rear floor duct or outlet, refer to Section 1A.
6.
Floor carpeting, refer to Section 10-10.
7.
Left and right front seats, refer to Section 10-10.
