Grand AM V6-3300 3.3L (1992)
Upper Side Moulding / Trim: Customer Interest
Side Moldings - Discolored/Stained Inserts
File in Section: 10 - Body
Bulletin No.: 63-15-05
Date: February, 1996
Subject:
Discolored or Stained Inserts in Side Moldings (Replace with Rear Fascia insert)
Models:
1992-95 Pontiac Grand Am
Condition
Some owners may comment on side molding inserts becoming discolored or stained.
Cause
This condition may occur from continued direct sunlight.
Correction
To correct this condition, it is necessary to replace the side molding inserts with rear fascia insert, P/N 22552498, (red) or 22646918 (bright) cut to fit,
following the procedure below.
1.
Remove inserts from side molding on fender, door(s) and rear quarter.
2.
Remove all traces of adhesive from side molding insert cavity with 3M® General Purpose Adhesive Cleaner or equivalent.
3.
Cut rear fascia insert to the proper sizes needed and seal ends of inserts with Kent Leak Check Clear Sealer, P/N 10200, or equivalent.
4.
Install inserts into side molding insert cavity and press firmly in place.
Parts Information
P/N
Description
22552498 (Red)
Rear Fascia Insert
22646918 (Bright)
Rear Fascia Insert
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation
Labor Time
B7430/31
0.2 hr
B7435/36
