Grand AM V6-3300 3.3L (1992)
Refrigerant Oil: Capacity Specifications
Current compressor systems require 240 ml (8 fl. oz.) of 525 viscosity refrigerant oil.
New 525 viscosity refrigerant oil must be added to the system when components are replaced, as follows:
a. All Compressors (drain and measure the oil)
^
If less than 30 ml (1 fl. oz.) is drained - add 60 ml (2 fl. oz.) to the new compressor.
^
If more than 30 ml (1 fl. oz.) is drained - add same amount that was drained to the new compressor.
b. Accumulator Dehydrator.
^
Add 105 ml (3.5 fl. oz.) to new accumulator.
c. Evaporator.
^
Add 90 ml (3 fl. oz.) oil.
d. Condenser.
^
Add 30 ml (1 fl. oz.) oil.
e. Refrigerant oil loss due to a large leak.
^
If the refrigerant charge is abruptly lost due to a large refrigerant leak, approximately 90 ml (3 fl. oz.) of refrigerant oil will be carried out of
the system with the refrigerant. Any failure that causes an abrupt refrigerant discharge will experience this oil loss. Failures that allow the
refrigerant to seep or bleed off over time do not experience this oil loss.
^
Upon replacement of a component which caused a large refrigerant leak, add 90 ml (3 fl. oz.) of new 525 viscosity refrigerant oil plus:
^
The required amount of oil for the particular component (as outlined above). Add the oil directly to the replaced component if possible. If the
oil cannot easily be added to the replaced part, add the oil to the accumulator.
