Grand AM V6-3300 3.3L (1992)
Ball Joint: Service and Repair
Fig. 2 Modified Outer Seal Protector
Fig. 6 Assembling Lower Ball Joint To Lower Control Arm
1.
Raise and support vehicle.
2.
Remove tire and wheel assembly, then install modified outer seal protector No. J34754 or equivalent, Fig. 2.
3.
Remove lower ball joint cotter pin and nut, then loosen ball joint from steering knuckle using tool No. J29330 or equivalent.
4.
Position a suitable pry bar between suspension support and lower control arm and separate lower ball joint from steering knuckle. On some
models, it may be necessary to remove nut attaching link to stabilizer shaft.
5.
Locate center of rivet body and mark with a center punch.
6.
Using a 1/8 inch drill, drill pilot holes completely through the rivets. Using a 1/2 inch drill, drill final holes through rivets to ensure fitting of new
ball joint.
7.
Remove ball joint from lower control arm.
8.
Assemble new ball joint to lower control arm with bolts provided in service package, Fig. 6. Torque bolts to specification.
9.
Insert ball joint stud into steering knuckle and torque nut to specifications, then install cotter pin.
10.
Install wheel and tire, check front wheel alignment.
