pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

All Other Service Bulletins for Heater Core: > < Heater - Inadequate Performance|Page 7175
Page 1
background image

Heater Core: All Technical Service Bulletins
A/C - Inadequate Heat Condition

Bulletin Number:

88-1-25

Reference Number:

831109R

Publish Date:

1/89

Subject:

INADEQUATE HEAT CONDITION

Models

Affected:

1988 GRAND PRIX EQUIPPED WITH C60

Some of the above vehicles, built prior to the VIN JF249646 breakpoint may experience inadequate heat condition due to a missing separator in the 
heater core.

If a vehicle exhibits this condition the following diagnostic procedure should be used:

1.

Run the vehicle until the thermostat opens. The vehicle must be at normal operating temperature.

Note:

This may be accomplished by (a) physically driving the vehicle to achieve operating temperature or (b) letting the vehicle idle in the
service area and visually monitor the coolant flow or record the coolant temperature using a thermometer via the radiator cap opening.
If method (b) is used, it may be necessary to block off the radiator to restrict air flow to aid in achieving operating temperature.

2.

The remaining procedure must be conducted at 60-80 degrees Fahrenheit ambient temperature in order to properly diagnose the heater core
performance.

Note:

Conducting this test at 60-80 degrees Fahrenheit will insure proper performance of the heater core in cooler ambience.

3.

Set control to HEATER mode.

4.

Set fan speed on HIGH.

5.

Engine speed at IDLE.

6.

Check the vehicle heater outlet temperature for several minutes with a thermometer.

Note:

The outlet temperature should be a minimum of 50 degrees Fahrenheit higher than the ambient temperature.

If outlet temperature is less than 50 degrees Fahrenheit above ambient, the heater core should be replaced with P/N 3091147.

Parts are currently available from GMSPO.

Warranty Information

Labor Operation:

T7765     Check heater performance (includes measuring air temperature at heater outlet).

Labor Time

:

.5 Hours

If necessary to replace heater core; use applicable labor operation and time.

All Other Service Bulletins for Heater Core: > < Heater - Inadequate Performance|Page 7175