Grand Prix V6-191 3.1L VIN M SFI (1998)
3. Lubricate the two bolt boots (5) in the caliper bracket (6). Use silicone grease.
NOTICE: Refer to Fastener Notice in Cautions and Notices.
4. Install the caliper bolts (1). Use a screwdriver in order to push the bolt boot over the shoulder of the caliper bolt. Ensure that the bolt boot fits
securely in the groove of the pin bolt.
^
Tighten the caliper bolts to 85 Nm (63 ft. lbs.).
IMPORTANT: Replace the copper gaskets.
5. Install the brake hose bolt, if removed.
^
Tighten the brake hose bolt to 54 Nm (40 ft. lbs.).
6. Remove the wheel nuts securing the rotor to the hub.
7. Install the tires and the wheels. Align the previous marks on the wheel and the hub.
8. Lower the vehicle.
9. Fill the master cylinder to the proper level with clean brake fluid.
10. Bleed the caliper if the inlet fitting was removed. Refer to Brake Bleeding.
11. Apply approximately 778 N (175 lb) of force to the brake pedal after bleeding, if necessary.
12. Inspect the hydraulic brake system for brake fluid leaks.
