Grand Prix V6-191 3.1L VIN M SFI (1998)
15. Dry all the parts with filtered, non-lubricated compressed air.
16. Blow out all the passages in the caliper housing and the bleeder valve. Use filtered, non-lubricated compressed air.
TOOLS REQUIRED
^
J 36349 Front Dust Boot Seal Installer
NOTICE: Refer to "Fastener Notice" in Service Precautions.
1. Install the bleeder valve and the bleeder valve cap to the caliper housing.
^
Tighten the bleeder valve to 13 Nm (115 in. lbs.).
2. Install a new lubricated piston seal into the caliper bore grooves. Ensure that the piston seal is not twisted.
3. Install the lubricated boot (1) onto the piston (2).
4. Lubricate the piston OD with clean brake fluid.