Grand Prix V6-191 3.1L VIN M SFI (1998)
^
Deterioration Replace the bracket boots if damage exists.
11. Inspect the piston boot for the following conditions:
^
Cuts
^
Tears
^
Deterioration Replace the piston boot if damage exists.
12. Inspect the caliper bolts for corrosion or damage. If corrosion exists, use new components (including bushings) when installing the caliper. Do not
attempt to polish away the corrosion.
INSTALLATION PROCEDURE
IMPORTANT: Before installing new brake pads, wipe the outside surface of the caliper boot clean. Use denatured alcohol.
1. Bottom the piston (7) into the caliper bore (2).Use a C-clamp when installing new brake pads in order to clamp the piston at the same time. Use a
metal plate or wooden block across the face of the piston. Do not damage the piston or the caliper boot.
IMPORTANT: Lift the inner edge caliper boot (4) next to the piston (7). Press out any trapped air. The boot must lay flat below the level of the
piston face.
IMPORTANT: The wear sensor is on the outside shoe. The sensor is positioned at the trailing edge (downward) of the pad during forward wheel
rotation.
2. Install the two retainers (11) to the caliper bracket (12).
3. Install the pads (9 and 10) to the caliper bracket (12).
NOTICE: Use care to avoid damaging pin boot when rotating caliper.
4. Swing the caliper upward in position around the pads.
5. Lubricate the bolt and the bolt boot. Use silicone grease.
NOTICE: Refer to Fastener Notice in Cautions and Notices.