Grand Prix V6-191 3.1L VIN M SFI (1998)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Pressure Modulator Valve Bracket Replacement
REMOVAL PROCEDURE
1. Turn the Ignition switch to the OFF position.
2. Remove Brake Pressure Modulator Valve (BPMV) and Electronic Brake and Traction Control Module (EBTCM) as an assembly from the
BPMV bracket.
3. Remove the three BPMV bracket nuts (1) (2) and (3) attaching the BPMV bracket (4) to the wheel housing.
4. Remove the BPMV bracket (4) from the vehicle.
INSTALLATION PROCEDURE
1. Install the BPMV bracket (4) to the wheel house.
2. Install the three BPMV bracket nuts (1) (2) and (3) to the studs on the BPMV bracket (4).
^
Tighten the three BPMV bracket nuts to 10 Nm (7 ft. lbs.).
3. Install the BPMV and EBTCM as an assembly to the BPMV bracket.
4. Turn the ignition switch to the RUN position. Perform the Diagnostic System Check
